Tom,
I think probably you missed it, but last Sunday/Monday there were numerous
discussions about the 'problem' I had on the reflector, and what I did to
resolve it. It is way too long to repeat here again. But under
circumstances, v1.371 will cause the problems mentioned. Good luck in the AA
test.
Tom - W4BQF
----- Original Message -----
From: "Tom Jednacz" <tjednacz@ieee.org>
To: <tentec@contesting.com>; <tentec@contesting.com>
Sent: Saturday, June 19, 2004 10:05 AM
Subject: Re: [TenTec] Orion 1.371 wierd one
>
>
> No problem here with 1.371. Been running All Asia CW test and no
problems.
> Have it connected to N1MM and not having a single problem. Could it be
that
> in downloading to the Orion a bit gets lost somewhere and causes your
> problem? Did you erase all RAM in the Orion (turning on the Orion while
> holding down the VFO B lock -LCK- button) and try to again down load 1.371
> to the Orion again?
> Tom, W7QF
>
> -------Original Message-------
>
> From: tentec@contesting.com
> Date: 06/19/04 09:40:35
> To: tentec@contesting.com
> Subject: Re: [TenTec] Orion 1.371 wierd one
>
> John,
>
> Unfortunately that IS a problem with v1.371. I spent most of last weekend
> troubleshooting that to no avail. I also had to go back to v1.370 which
> totally eliminated all of those problems. Ten Tec is aware of this problem
> and have been working on getting it fixed.
>
> Tom- W4BQF
> ----- Original Message -----
> From: "john, ke5c" <ke5c@hot.rr.com>
> To: "Ten-Tec Reflector" <tentec@contesting.com>
> Cc: <ditsnbits@tentec.com>
> Sent: Friday, June 18, 2004 8:59 PM
> Subject: [TenTec] Orion 1.371 wierd one
>
>
> > I don't see a posting about this, but I've been running 1.371 almost
since
> > it came out but I've been busy and not QRV often. Tonite in the middle
of
> a
> > CW QSO while transmitting, it quit. My Centurion remained keyed, but no
> CW.
> > I power cycled the Orion, and same thing - if I started to transmit, the
> > Orion would go into transmit mode, but no CW - no sidetone, no power.
> > Finally I did a master reset, and it went back to working - very
briefly,
> > maybe a minute of CW. Then the same thing showed up. After two more
> master
> > resets, I was beside myself since this Orion is supposed to be our
club's
> CW
> > rig for Field Day. Just for grins, I reloaded 1.370 and all is back to
> > normal, at least for now. This is just FYI, and no, I wasn't running the
> > dreaded spectrum display.
> >
> > 73, John
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> ----------------------------------------------------
> This message has been processed by Firetrust Benign.
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|