Every TenTec radio I have owned has had a TX offset to some degree. If I
set my ts2000 to 3.750, I have to set me Omni6+ to 3.748 to match it. My
Paragon did this as well as my omni C and my 580 Delta. Anytime I am give a
net frequency I always tune slightly below it and everybods sounds fine.
This may or may not be what you are discribing though.
----- Original Message -----
From: "keyer" <telegrafiste@tiscali.fr>
To: <tentec@contesting.com>
Sent: Friday, December 24, 2004 11:07 AM
Subject: [TenTec] Omni VI TX/RX Frequency discrepency
> I have just determined that my Omni 6 Option 3 has a 270Hz difference in
> frequency between TX and RX. I have a 7040 kHz xtal generator and
> several other rigs to compare things with.
> (much worse than having two watches!)
> When the Omni is set to receive 7040 kKz then on TX its actual
> Frequency, measured on another known good rig is 703973 ie 270Hz low.
> All measurements were done very carefully on CW, with narrowest filters
> in use.
> I assume I can correct this, can anyone point me in the right direction,
> I have the standard TT manual.
>
> Any help appreciated.
>
> 73 and seasons greetings to all TT fans
>
> Deni, F5VJC / GM3SKN
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Anti-Virus.
> Version: 7.0.298 / Virus Database: 265.6.4 - Release Date: 12/22/2004
>
>
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.298 / Virus Database: 265.6.4 - Release Date: 12/22/2004
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|