HI,
Yes it is in the ACOM. I have full instruction to do that mod. I can send
via mail instructions and photos.
It requests to be experienced because of high voltage into the ACOM.
Today, while testing, I got an "ARC FAULT" error when I selected TX and RX
buttons on different VFOs (which were not in the same band).
It seems that if TX freq. and RX freq. are different something wrong happens
.. also if you swap only the receiving VFO (!!!).
Any idea? thank you
73 Frank I2DMI
C82 and the 200K rsistor are in the ACOM 2000. This is an ACOM mod and not
an Orion mod.
Carl Moreschi N4PY
Franklinton, NC
----- Original Message -----
From: "Tommy" < <http://lists.contesting.com/mailman/listinfo/tentec>
aldermant at alltel.net>
To: < <http://lists.contesting.com/mailman/listinfo/tentec> tentec at
contesting.com>
Sent: Tuesday, December 28, 2004 4:49 PM
Subject: Re: [TenTec] Orion / ACOM 2000A problem solved
> Frank,
>
> Thanks for you info.
>
> Where was the C82 and the 220k resistor that you changed located? On
> the ACOM or the Orion?
>
> Thanks.
>
> Tom - W4BQF
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|