Will,
Let's start with the basics and check all of the internal cables on the OMNI
6 for a good conection. Re-seat all of the cables and see what happens.
Good luck & 73,
Dave, K2DP, St. Louis
OMNI 6+ here
----- Original Message -----
From: <wlbaber@bellsouth.net>
To: <tentec@contesting.com>
Sent: Sunday, March 13, 2005 7:21 PM
Subject: [TenTec] Omni VI, opt3 problem
After 7 or 8 years my first difficulty with Omni VI...no signals on 20
meters but audio, and audio and signals on all other bands. No power
output on all bands but low-level signal is there. I know it has to go
back, but wonder if anyone can comment on what may be the problem. I went
into it to adjust the bfo, which was off a significant amount--couldn't
quite at the LSB BFO to 9.000 Mhz but close enough. Put covers back on,
and was in receive when it stopped receiving on 20 meters.
I'll bet I'm no the only one! Thanks.
73, will, wj9b, dit dit
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|