Re: [TenTec] NO XMIT WITH PTT

[Ron <k8fg@sbcglobal.net>]

Steve N4LQ wrote:

> Ron
> Tx Loop button? What's that? In the "Transmitter" menu, I have a "Enable 
> keying loop" button. Is that what you meant? I have mine disabled since I 
> don't use a TT amp with the Peg. On your N4PY front panel, do you have the 
> "Xmit Disable" activated? If so, disable it. Also check the "ACCInp" button. 
> For microphone input it should be disabled.
> If all this doesnt work, try the basic TenTec software and start all over.
> Out of ideas. 73
> Steve Ellington
> N4LQ@iglou.com
> ----- Original Message ----- 
> From: "Ron" <k8fg@sbcglobal.net>
> To: <tentec@contesting.com>
> Sent: Saturday, March 19, 2005 2:16 PM
> Subject: [TenTec] NO XMIT WITH PTT
>
>
>  
>
> > Hello to the Group,
> > I have a couple of questions .
> > I have a Pegasus that will not Xmit via the Mic or Acc jacks
> > but will key via the N4PY software with a mouse click on the
> > TX Loop button.. Any ideas ?
> >
> > Also is there ant service info available ?
> > Thanks, Ron/K8FG...
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> >    
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>  
Hi Steve and Carl,
I have the latest ver of software and in the top row of buttons there is 
a Tx Loop button after the Calibrate.
When I left click on this button it will go into xmit. If I go into the 
settings/transmitter menu and
uncheck Keying Loop the rig goes into xmit. ACCInp is disabled.
I am starting to believe I have a rig problem, if I short the Ptt pin in 
the mic connector to ground
there is no xmit also did the same test with the Acc connector with the 
same results.
Ron/K8FG...