| To: | "Discussion of Ten-Tec Equipment" <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] care and feeding of TiTan fan .. |
| From: | "Tim Heasman" <tim@sideswiper.plus.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Fri, 25 Mar 2005 13:42:52 -0000 |
| List-post: | <mailto:tentec@contesting.com> |
Hi All,I have an original Titan that has not been used for about10 years. I am now very concerned that the PSU might have problems if I was to power it up. I do remember that my fan was rather noisy when I first purchased the amp. The noise was from the fan unit being too tightly coupled to the chassis. As far as I remember I just slackened the fixing bolts a little, and this reduced the noise from the motor considerably. If it is the air noise due to the flow rate that is bothering you I would not recommend that you reduced the flow rate by any means as those tubes are getting very expensive. Get noise reducing mic and headphone set instead. 73Tim g4lmh |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Zero Beat, Lee Crocker |
|---|---|
| Next by Date: | Re: [TenTec] care and feeding of TiTan fan .., Bill NY9H |
| Previous by Thread: | Re: [TenTec] care and feeding of TiTan fan .., Tommy |
| Next by Thread: | Re: [TenTec] care and feeding of TiTan fan .., Bill NY9H |
| Indexes: | [Date] [Thread] [Top] [All Lists] |