Gary
I sometimes find it hard to tell if the NR is working or not. Band noise is
still there. But I find that if I let the NR "do its thing" the S meter
gradually declines and even though I still hear noise - it is at a much lower
level than before. My natural inclination was to crank up the audio gain a
little bit so I could "hear" the radio. Then when a signal comes on, it
really
jumps out at you.
I have found that you must push the button firmly. A partial push or a
light touch will change the display but not engage the NR. I know that makes
no
sense but that is the way it works on my Orion. I use a setting of 3 as I
find that reduces the noise in about a second or two with a minimum of
distortion.
k4ia
Craig "Buck"
Fredericksburg, Virginia USA
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|