I don't recall the firmware revision my Orion had when I bought it but I do
recall turning on the NR and my jaw dropping. It was awesome. All the band
noise vanished and I none of the goofy dsp artifacts that most rigs have.
Then I "upgraded" to a new firmware and the NR ceased to work. Pushing the
button had a tiny effect but it was almost useless. I tried many master
resets to no avial. I think we see different opinions here because some NRs
are working and some are not or not much.
Steve Ellington
N4LQ@iglou.com
----- Original Message -----
From: <K4IA@aol.com>
To: <tentec@contesting.com>
Sent: Tuesday, June 14, 2005 8:29 AM
Subject: Re: [TenTec] Orion NR problem
Gary
I sometimes find it hard to tell if the NR is working or not. Band noise
is
still there. But I find that if I let the NR "do its thing" the S meter
gradually declines and even though I still hear noise - it is at a much
lower
level than before. My natural inclination was to crank up the audio gain
a
little bit so I could "hear" the radio. Then when a signal comes on, it
really
jumps out at you.
I have found that you must push the button firmly. A partial push or a
light touch will change the display but not engage the NR. I know that
makes no
sense but that is the way it works on my Orion. I use a setting of 3 as
I
find that reduces the noise in about a second or two with a minimum of
distortion.
k4ia
Craig "Buck"
Fredericksburg, Virginia USA
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|