| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Ten Tec Net |
| From: | w8au@sssnet.com |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Wed, 20 Jul 2005 03:35:05 -0400 |
| List-post: | <mailto:tentec@contesting.com> |
At 03:45 AM 7/19/05, you wrote: I checked out my Paragon II manual, and sure enough there is a control line which causes RX input RF to bypass the first amplifier stage only when in 0.100 - 1.7 MHz. Looks like I could just disconnect one cable for a quich test of this. It is connector 16 on the first mixer schematic. Glad to hear that the rigs are similar in this respect. You should notice 12-15 dB improvement in sensitivity as I did. Have fun....Perry |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Tuner for Centurion to balanced antenna, Gregory J Knapp |
|---|---|
| Next by Date: | [TenTec] Clarity on Palstar Matchboxes, NJ0IP |
| Previous by Thread: | Re: [TenTec] Ten Tec Net, Ken Brown |
| Next by Thread: | Re: [TenTec] Ten Tec Net, Robert & Linda McGraw K4TAX |
| Indexes: | [Date] [Thread] [Top] [All Lists] |