TenTec
[Top] [All Lists]

Re: [TenTec] 2.028 is out - error message

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] 2.028 is out - error message
From: "Carl Moreschi" <n4py@arrl.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 9 Jan 2006 22:57:38 -0500
List-post: <mailto:tentec@contesting.com>
When your flash utility first starts, select "Settings".  In here you will
be able to define which comport the Orion II is connected to.  Once you have
done this, then power off your OII.  Then hold down the "recall" button and
power on.  Do not release the button until the OII says "Flash update mode".
Once the OII is in flash update mode, click "Process" in the flash update
utility.  This should get you going.

Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message ----- 
From: <RaySoifer@cs.com>
To: <tentec@contesting.com>
Sent: Monday, January 09, 2006 10:42 PM
Subject: Re: [TenTec] 2.028 is out - error message


> Please forgive this dumb question, but now that I've downloaded the new
> firmware, what do I do now?
>
> I plugged the serial port into both computer and O2, installed the
software
> into the computer, hit "process" and selected "install 2.028."  It begins
the
> process only to give me an error message "Communication with the radio has
> failed."
>
> I have a feeling that I was supposed to do something to configure the
serial
> port(s), but I cannot find anything that tells me what to do.
>
> Can one of you experts shed some light?
>
> Tnx,
>
> Ray W2RS
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>