TenTec
[Top] [All Lists]

Re: [TenTec] Orion II Curiosity

To: "Martin, AA6E" <martin.ewing@gmail.com>,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Orion II Curiosity
From: Barry LaZar <k3ndm@verizon.net>
Reply-to: k3ndm@verizon.net,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 09 Jan 2006 08:10:52 -0600 (CST)
List-post: <mailto:tentec@contesting.com>
Martin,
     The TS-50 does have some speech processing. I never discovered how much. 
     I run the SP at 4 on the Orion II. I want punch not hifi for DX. In fact, 
that's what started this. I was unable to break through a pile up I thought I 
should have, but let's not go down that path. There does appear to be about a 3 
db difference in indication between the two radios that I did not expect. I was 
hoping someone could point me to what I'm missing. It may be nothing more than 
I need more time with the radio to better learn its operation as compared to 
others.


73,
Barry
K3NDM


>From: "Martin, AA6E" <martin.ewing@gmail.com>
>Date: Sun Jan 08 21:38:31 CST 2006
>To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
>Subject: Re: [TenTec] Orion II Curiosity

>I agree with the previous comments that good speech (hi fi!) will have
>a very low average power, but should show occasional peaks to 100W. 
>That is part of why you get the good audio reports with the Orion!  If
>you want more "punch" and don't care so much about fidelity (dynamic
>range), that's what the SP control is for.  Higher SP gives higher
>average power and lower peak-to-average ratio.  But that's not hi fi. 
>Your TS-50 may have some speech processing always on-line.
>
>Full disclosure - I rarely run SSB with SP less than 2, and I still
>get fine reports.
>
>73 Martin AA6E
>
>On 1/8/06, Duane A Calvin <ac5aa@juno.com> wrote:
>> Barry,
>>         It might help if you give more details on the meter, where it is
>> placed and whether you have any SWR which might be reading differently on
>> the Orion than on the TS-50.  If you have a dummy load, have you tried
>> driving it into that?  Also, is your red ALC LED flashing on peaks like
>> it should?  Finally, an indication of where the Orion's power meter runs.
>>
>>         Driving my Orion into a dummy load, my PowerMaster digital meter
>> shows voice peaks at ~95W, and if I whistle, it reads 103-106W.  ALC LED
>> flashing on voice peaks, power meter reads 100 (does not follow voice
>> peaks, one of the weaker items in the Orion design.)  Hope this helps a
>> little.
>>
>>         73,  Duane
>>
>--
>martin.ewing@gmail.com
>http://blog.aa6e.net
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>