TenTec
[Top] [All Lists]

Re: [TenTec] ORION_NO_REC_ON_SUB_CHARLIE

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] ORION_NO_REC_ON_SUB_CHARLIE
From: "George K" <w2yj@highstream.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 22 Jan 2006 21:50:25 -0500
List-post: <mailto:tentec@contesting.com>
Charlie;
My Orion had no sub receiver receive. Only funny sounds that were not 
changed when I tuned the sub VFO up and down in frequency.

I'll try my best to tell you how I removed and replaced the SAME battery. 
There is no need to actual put a new battery in if the original one is OK 
and it probably is.

Take the top off. You'll need a funny hex screw tip screw-driver of sorts to 
take those funny screws off in the back.
Take the top off then take the bottom off. On the bottom you'll see a small 
round battery. Remove it and wait for a minute then put the SAME battery 
back in.
This erases the RAM memory that Ten Tec said a RAM clear does but I tried a 
RAM clear on mine and that didn't solve the problem. The removal of the 
battery and putting the SAME battery back in fixed the problem in mine. Not 
saying yours will act the same way but it's worth a Ham try!
George


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>