George, This is a great lesson and thanks.
I've found on some bands more than others the proximity of the antenna to
the shack was a factor relative to this kind of problem, i.e if the beam is
over the roof and not away from the house. This is common sense I guess,
but it complicates the situation. And when someone says there is only one
or two ways to solve the bonding challenge (grounding) I don't believe it.
There are many ways, length of braid, etc etc.
But in the end, I believe if we keep it simple.. no extra coax rolled up
behind the table/desk, as few connectors and 'things' in the line as
possible, VERY GOOD coax with first class connectors/installation, and
everything tight .. this will help any 'shack'. Often times this isn't the
case nor is regular maintenance a way of life.
Thanks for your effort and again a lesson learned.
73, Lynn W4NL
----- Original Message -----
From: "George K" <w2yj@highstream.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, March 01, 2006 7:57 AM
Subject: [TenTec] MY_ORION&O2_RF_IN_MIC-PROBLEM_SOLVED!!
Ever since I've had my Orion and now the Orion2 I have had RF in the mic
distorting my SSB signal on 20 meters. It only happens when I run high
power and only on 20 meters.
I presently run a O2, TT 706 mic, Ameritron AL-1500, Steppir 3 element
beam fed with 9913 coax.
I've tried every know remedy known to hams to solve this problem.
I solved it, finally, by taking the TT 706 mic apart, insulating the PC
board, and then making a pouch using my wife's kitchen foil wrap for the
PC board in the 706 mic. I left a tab on the pouch that connects to the
ground lug. The RF mic board is now shielded.
PROBLEM SOLVED!!!
Don't know why I had RF in the shack but at this point I don't care.
It doesn't help that the 706 mic has a plastic upper shell.
Maybe this will help someone else.
George
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|