When I measure the audio response, I find that the width at -6dB is 107hz
and at -60dB it's 298hz
Spectrum taken shown at http://n1eu.com/100hz_v2056.gif
73, Barry N1EU
On 3/11/06, Sinisa Hristov <shristov@ptt.yu> wrote:
>
> The following 100 Hz DSP CW filter response was measured
> with a calibrated signal fed directly to ADC input on A7 board.
>
> 156 Hz width at -6 dB
> 378 Hz width at -40 dB (sidelobe peak)
> 512 Hz width at -49 dB (sidelobe peak)
> 660 Hz width at -56 dB (sidelobe peak)
> 796 Hz width at -62 dB (sidelobe peak)
> 463 Hz width at -67 dB (sidelobe peak)
> 1072 Hz width at -70 dB (sidelobe peak)
> 1210 Hz width at -75 dB (sidelobe peak)
>
> Both S meter and AGC respond happily to sidelobes as measured.
> The response is essentially the same as with V1 firmware.
>
> V2 apparently introduces an additional audio filter preventing
> sidelobes from being heard, which may be useful in some circumstances,
> although many would not call it "real" selectivity as the AGC is
> still being keyed by strong signals more than half a kHz away.
>
> Selectivity measurements by spectral analysis of the audio response
> to white noise will show combined selectivity of IF and audio filters.
>
> I wouldn't consider this a bug.
> It is an "unpublished feature", although somewhat misleading one.
>
>
> 73,
>
> Sinisa YT1NT, VE3EA
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|
