TenTec
[Top] [All Lists]

Re: [TenTec] [Orion] [orion565] new firmware

To: "TenTec List" <TenTec@contesting.com>
Subject: Re: [TenTec] [Orion] [orion565] new firmware
From: "Rick Williams" <rick.williams@telus.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 28 Apr 2006 20:56:40 -0700
List-post: <mailto:tentec@contesting.com>
Thanks for the clarification Barry.  Mine does the same on the headphones.
So I guess that a variant of the problem exists on the O1 with 2.056.

I wonder if anyone has reported it to ditsnbits?

73, 

Rick 
VE7TK

Website:  http://www3.telus.net/ve7tk  


----------------------------------------
Date: Sat, 29 Apr 2006 01:48:44 +0000
From: "Barry Gross" <barry.n1eu@gmail.com>
Subject: Re: [TenTec] [Orion] [orion565] new firmware

On 4/28/06, Rick Williams <rick.williams@telus.net> wrote:
>
> Barry I just retried AM (100 watts into a dummy load) and MON function and
> I
> cannot duplicate the problem you have report?


My rig does it consistently, even after a master reset, but it's only the
main/sub headphone audio that's lost - the speaker audio is fine.  I lose
the headphone rx audio every time after a single AM xmsn, independent of
whether the monitor is on or not.

Besides power cycling, I'm finding that switching to cw and xmitting will
also bring back the rx headphone audio.

73,
Barry N1EU

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>