Glad to hear you were able to get all the ports Jack. I have only had to
buy
the ByteRunner card with 2 serial and 1 lpt port so far, and that has to
be
around 12 years ago. If I do a format, I just go to their site and get XP
drivers. There is a different set for Win 2k. I need to go there and burn
them to a cd so just in case, I'll always have them. They even still sell
ISA ports. With the PCI card I have, it came with a disk for the drivers
and
of course 12 years ago, Dos was still the OS a lot of us used for our ham
radio computers anyway. This has a Dos driver that takes some configuring,
with a small program written in Germany. I can think of only one program
it
wouldn't work with. It loads what it calls "virtual drivers" at Dos boot
up.
Sorry to get off on a non Ten Tec tangent. How about this, it always
worked
great with my Omni 6 opt 3 !
73 and enjoy Dayton.
Mike, K9MI
----- Original Message -----
From: "jack" <jfriend31@comcast.net>
To: <tentec@contesting.com>
Sent: Friday, May 19, 2006 03 55
Subject: [TenTec] adding serial ports to computer
after doing much checking as to USB to Serial, i took the suggestion that
i add a PCI serial port card to my desktop. today i found a small
computer
store that actually had a PCI I/O card with two serial ports and a
parallel port. i just installed the card and drivers. now my desktop has
4
serial ports and 2 parallel ports. all for a few moments and $30.15.
simple is the word for desktops if one has the slot available. finding
the
card is more difficult than installation by far.
jack ak7o
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec