TenTec
[Top] [All Lists]

Re: [TenTec] circuits in modules

To: roncasa@verizon.net,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] circuits in modules
From: Bwana Bob <wb2vuf@gti.net>
Reply-to: wb2vuf@arrl.net,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 13 Jul 2007 10:51:44 -0400
List-post: <mailto:tentec@contesting.com>
There really isn't anything exotic in the Scout modules. There are 2 
plug-in boards in the housing. One has the TX bandpass filter, all 
passive components, and the other has a crystal oscillator, low pass 
filter, and mixer for the band. They would be easy to duplicate, if it 
wouldn't violate a Ten Tec patent. The hard part would be fabricating a 
case to replace the plastic housing made by Ten Tec and doing the 
alignment of the BPF. That might require a sweep generator, but I bet 
something simpler could be rigged up.

                                73,

                                Bob WB2VUF

ron wrote:
> On Thu, 2007-07-12 at 18:42 -0700, Ed Purvis wrote:
>> The modules being no longer available new
>>       makes me curious to know what circuits
>>       are in them and can they be duplicated?
>>
>  
> 
> simple, just pick up a owner's manual.
> 
> Ron, wb1hga
> "Got Linux?"
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
> 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>