Amen! This is one of my few gripes about the Orion II. I do a lot of weak signal 80 meter work and going
from the RF gain to NB, AN, etc. by way of the buttons and then back to a button so I can
“ride” the RF gain control is a pain in the neck. A way to re-program the “basically
redundant and useless Hi Cut/ Lo Cut knob” to a RF gain control (or a mod to add a RF gain control)
would be great!
Maybe Ten-Tec is listening.
Scott K4VWK
-----Original Message-----
From: "Michael, Dana A" <dana.michael@tycoelectronics.com>
Sent: Feb 1, 2008 9:19 AM
To: tentec@contesting.com
Subject: [TenTec] ORION II CW pile up readability
If you are to operate "riding" the RF gain control, then why is there
not a knob dedicated to this function only? Or why can't I reassign my
basically redundant and useless Hi Cut/ Lo Cut knob to be the RF Gain? I
don't like the "multi" knob for a function I need to use constantly.
Always having to "recall" it to RF Gain after I try the NR or NB or
Notch.
73, Mike W3TS
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.5.516 / Virus Database: 269.19.18/1254 - Release Date: 1/31/2008 8:30 PM