On Tue, May 13, 2008 at 9:41 AM, John <fraz1@bellsouth.net> wrote:
> Interesting. I was a beta user for the most recent release. I did not find
> the SSB output issue to be fixed. It would not "hold" the power level,
> especially when driving the amp.
John, after properly setting your mic gain (ALC), you need to adjust
your config TXG VCE setting to equalize your amp's output between cw
and ssb.
This is an issue for the Elecraft reflector or private email though,
not the Ten-Tec reflector.
73,
Barry N1EU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|