I doubt the value of an after-tuner filter - the filter needs to see a good
match fore-and-aft. Ron is so right about the chances of filter damage -
that would mean a good part of your output is going for heat. Remember,
too,the tuner can assist greatly in harmonic suppression.
----- Original Message -----
From: "Ron Castro" <ronc@sonic.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, May 18, 2008 4:48 PM
Subject: Re: [TenTec] Low Pass Filter
> The unit after the tuner may be subject to very high SWR unless your
> antennas are all have fairly low SWR. A severe mismatch could cause
> voltage
> or current sufficient to damage the second unit.
>
> But like they say, "If it ain't broke, don't fix it"!
>
>
> Ron N6IE
> www.N6IE.com
>
>
> ----- Original Message -----
> From: "Gary Hoffman" <ghoffman@spacetech.com>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Sunday, May 18, 2008 1:09 PM
> Subject: Re: [TenTec] Low Pass Filter
>
>
>>I use two, and its probably overkill.
>>
>> I use one before the linear, and then I use one that comes after the
>> antenna
>> tuner (and linear). I'd guess I get very little additional bang for the
>> buck that way, but it is also true that I have never caused any TVI.
>>
>> 73 de Gary, AA2IZ
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|