i have never needed any repair for my Orions,
jack ak7o
----- Original Message -----
From: "John K Gotwals" <john@gotwals.com>
To: <tentec@contesting.com>
Sent: Tuesday, December 23, 2008 10:25 AM
Subject: [TenTec] Repair history for Orion
Listed below is the repair history for my Orion. I have been very happy
with
Ten-Tec's service, but I am curious if my service history for my Orion
approximates the experiences of others.
Orion purchased new from factory in August, 2005
Replaced fried logic board components in March, 2007
Replaced bad capacitors on power distribution board in July, 2007
Replaced bad display and bw encoder in December, 2008
Luckily it is only a one-hour drive from my house to Ten-Tec, so I did not
need to go through the pain of packing and unpacking the Orion for
shipment
by carrier.
Does this repair history seem about right for an electronic unit as
complex
as an Orion? I should mention that my operating environment has sometimes
been in an rf-hot environment.
John, N9JG
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|