TenTec
[Top] [All Lists]

Re: [TenTec] Repair history for Orion

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Repair history for Orion
From: "Ron Castro" <ronc@sonic.net>
Reply-to: Ron Castro <ronc@sonic.net>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 24 Dec 2008 09:19:48 -0800
List-post: <mailto:tentec@contesting.com>
My O2, from the very first production run of December 2005 (I bought it in January 06 after the original owner sent it back) has had only one trip back to Dolly Parton Parkway and that was for the well-known power distribution board problem. The second time that happened, I fixed it myself. I also installed and tested a prototype of the plug-in board that fixed the headphone RFI problem and is now standard on all new O2's. I use my Orion II every day, usually for 6-8 hours on weekdays, and 14-16 hours on weekends. I do SSB, CW and RTTY contests and DX as well as ESSB, all in a very high RF environment.

Recently, a big contester moved in about 1.5 miles away and I have measured his 160 m signal at about -13 dBm (an honest S9+60!) on my sloper, yet in the recent 160 contest, I was able to work stations as close as 500 Hz away from him while he was CQing. At 3 kHz away, I didn't even know he was there!

        Ron   N6IE
     www.N6IE.com

           Art WA8VSJ
----- Original Message ----- From: "John K Gotwals" <john@gotwals.com>
To: <tentec@contesting.com>
Sent: Tuesday, December 23, 2008 12:25 PM
Subject: [TenTec] Repair history for Orion


Listed below is the repair history for my Orion. I have been very happy
with
Ten-Tec's service, but I am curious if my service history for my Orion
approximates the experiences of others.

Orion purchased new from factory in August, 2005
Replaced fried logic board components in March, 2007
Replaced bad capacitors on power distribution board in July, 2007
Replaced bad display and bw encoder in December, 2008

Luckily it is only a one-hour drive from my house to Ten-Tec, so I did not
need to go through the pain of packing  and unpacking the Orion for
shipment
by carrier.

Does this repair history seem about right for an electronic unit as
complex
as an Orion? I should mention that my operating environment has sometimes
been in an rf-hot environment.

John, N9JG

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec



<Prev in Thread] Current Thread [Next in Thread>