| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] G5RV |
| From: | Ralph Matheny <mathenyr@marietta.edu> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Tue, 3 Feb 2009 20:55:33 -0500 (EST) |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
More quotes from Mr. Varney, G5RV's article: "For installation in very limited areas, the dimensions of both the flat top and matching sections can be divided by a factor of two....." "By far the most efficient feeder is the open-wire type......In this case the matching section becomes ... part of the feeder." Ole Louis embraced all these concepts discussed in this seemingly endless discussion; as somebody said earlier, a G5RV is simply a doublet spoilt" Read what the man said..... I shall say no more. Ralph Matheny K8RYU 207 Gibbons Place Marietta Ohio 45750 mathenyr@marietta.edu _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] RF speech processors, Merle Bone |
|---|---|
| Next by Date: | [TenTec] Orion at QRP levels, Ralph Matheny |
| Previous by Thread: | Re: [TenTec] G5RV, Bill Rowlett |
| Next by Thread: | Re: [TenTec] G5RV, Bob Close |
| Indexes: | [Date] [Thread] [Top] [All Lists] |