| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Orion 1 power connector |
| From: | Richards <jruing@ameritech.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 18 May 2009 21:03:16 -0400 |
| List-post: | <mailto:tentec@contesting.com> |
I think you can take the current connector off and solder new leads. ========== Just one idea... K8JHR =================== John Huffman wrote: I took the existing cable and cut it off 3" from the connector. I then put Anderson Power poles on the end so I have a 3" pigtale ============================================= |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Ten Tec Advertising, Richards |
|---|---|
| Next by Date: | Re: [TenTec] New Orion 1 - 2.063Xg, Art Lewis |
| Previous by Thread: | Re: [TenTec] Orion 1 power connector, John Huffman |
| Next by Thread: | Re: [TenTec] New Orion 1 - 2.063Xg, Art Lewis |
| Indexes: | [Date] [Thread] [Top] [All Lists] |