N4PY software is not available under Linux. But it does handle the audio
both ways and connects via an IP address.
Carl Moreschi N4PY
121 Little Bell Mountain Drive
Hays, NC 28635
www.n4py.com
----- Original Message -----
From: "Steve Halliburton" <wa2soc@hsix.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, July 27, 2009 1:26 PM
Subject: Re: [TenTec] One Plug under Linux
>I wasn't aware that it was
> 1. Available under Linux
> 2. Capable of handling the audio both ways
> 3. Connecting via IP rather than serial
>
> I guess I'll have to check it out.
>
> 73
> Steve WA2SOC
>
>
> Richards wrote:
>> Have you tried N4Py's software? Runs the rig... runs
>> circles around OnePlug. Runs your errands... OK...
>> two out of three are true.
>>
>> ============= K8JHR =================
>>
>> Steve Halliburton wrote:
>>
>>
>>> Thanks, Jack, but the software I'm interested in is much
>>> more than logging. One Plug actually becomes the radio,
>>>
>>
>> ======================================
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|