Re: [TenTec] having problem getting amp to work with Orion II

["John" <fraz1@bellsouth.net>]

That is correct John!

73 John W4II
----- Original Message ----- 
From: "John Molenda" <brazos@rochester.rr.com>
To: "aa4nn" <aa4nn@earthlink.net>; "Discussion of Ten-Tec Equipment" 
<tentec@contesting.com>
Sent: Monday, March 22, 2010 5:19 PM
Subject: Re: [TenTec] having problem getting amp to work with Orion II


> I have reread the manual and looked at the hookup my question is this (when
> hooking Orion II to titan III amp ) there are only two cables to run 
> between
> the two tx en out  key in out .  and then use the switch on the amp in qsk
> mode .  then go to the tx menu and enable loop 1 .  is this correct am I
> missing a hookup ?  thanks John kb2huk
> ----- Original Message ----- 
> From: "aa4nn" <aa4nn@earthlink.net>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Monday, March 22, 2010 9:14 AM
> Subject: Re: [TenTec] having problem getting amp to work with Orion II
>
>
> > Does the term QSK or PTT ring a bell?
> > de Joe, aa4nn
> > Lake Wylie, SC
> > ------------------------------------------------------
> > > > Hello all , I am having a problem getting my Orion II to work with my
> > > > Titan III
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

--------------------------------------------------------------------------------



No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.437 / Virus Database: 271.1.1/2763 - Release Date: 03/22/10 
07:33:00