Re: [TenTec] having problem getting amp to work with Orion II

["John Molenda" <cdistflatfoot@gmail.com>]

carl could you please clairify #2  thanks  John
----- Original Message ----- 
From: "N4PY2" <n4py2@earthlink.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, March 22, 2010 10:32 PM
Subject: Re: [TenTec] having problem getting amp to work with Orion II


> John,
> >
> 1) Turn on TXloop for antenna 1 on the orion.
> 2) Connect TXEN to TXOUT on the Orion.
>
> Does the Orion now key when you try to transmit?  It should.
>
> If that works, then connect TXOUT to the Titan key in.  Connect the Titan
> key out to the Orion TXEN.  The Orion should still key.  So exactly what
> does not work.
>
> Carl Moreschi N4PY
> 121 Little Bell Mountain Dr
> Hays, NC 28635
> www.n4py.com
>
> Try this:
> ----- Original Message ----- 
> From: "John Molenda" <cdistflatfoot@gmail.com>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Monday, March 22, 2010 9:15 PM
> Subject: Re: [TenTec] having problem getting amp to work with Orion II
>
>
> > I just check continuity of the two rca plugs and the coax it checks out
> > good
> > .  John kb2huk
> > ----- Original Message ----- 
> > From: "John Molenda" <brazos@rochester.rr.com>
> > To: <ac5aa@ac5aa.com>; "Discussion of Ten-Tec Equipment"
> > <tentec@contesting.com>
> > Sent: Monday, March 22, 2010 7:02 PM
> > Subject: Re: [TenTec] having problem getting amp to work with Orion II
> >
> >
> > > roger coax connected
> > > ----- Original Message ----- 
> > > From: "Duane Calvin" <ac5aa1@gmail.com>
> > > To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
> > > Sent: Monday, March 22, 2010 6:51 PM
> > > Subject: Re: [TenTec] having problem getting amp to work with Orion II
> > >
> > >
> > > > Oops - three cables - don't forget the exciter RF!  :-)
> > > >
> > > > Duane Calvin, AC5AA
> > > > Austin, Texas
> > > > www.ac5aa.com
> > > >
> > > >
> > > > -----Original Message-----
> > > > From: tentec-bounces@contesting.com
> > > > [mailto:tentec-bounces@contesting.com]
> > > > On Behalf Of John
> > > > Sent: Monday, March 22, 2010 5:35 PM
> > > > To: Discussion of Ten-Tec Equipment
> > > > Subject: Re: [TenTec] having problem getting amp to work with Orion II
> > > >
> > > > That is correct John!
> > > >
> > > > 73 John W4II
> > > > ----- Original Message ----- 
> > > > From: "John Molenda" <brazos@rochester.rr.com>
> > > > To: "aa4nn" <aa4nn@earthlink.net>; "Discussion of Ten-Tec Equipment"
> > > > <tentec@contesting.com>
> > > > Sent: Monday, March 22, 2010 5:19 PM
> > > > Subject: Re: [TenTec] having problem getting amp to work with Orion II
> > > >
> > > >
> > > > > I have reread the manual and looked at the hookup my question is this
> > > > > (when
> > > > > hooking Orion II to titan III amp ) there are only two cables to run
> > > > > between
> > > > > the two tx en out  key in out .  and then use the switch on the amp in
> > > > > qsk
> > > > > mode .  then go to the tx menu and enable loop 1 .  is this correct am
> > > > > I
> > > > > missing a hookup ?  thanks John kb2huk
> > > > > ----- Original Message ----- 
> > > > > From: "aa4nn" <aa4nn@earthlink.net>
> > > > > To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> > > > > Sent: Monday, March 22, 2010 9:14 AM
> > > > > Subject: Re: [TenTec] having problem getting amp to work with Orion II
> > > > >
> > > > >
> > > > > > Does the term QSK or PTT ring a bell?
> > > > > > de Joe, aa4nn
> > > > > > Lake Wylie, SC
> > > > > > ------------------------------------------------------
> > > > > > > > Hello all , I am having a problem getting my Orion II to work with
> > > > > > > > my
> > > > > > > > Titan III
> > > > > > _______________________________________________
> > > > > > TenTec mailing list
> > > > > > TenTec@contesting.com
> > > > > > http://lists.contesting.com/mailman/listinfo/tentec
> > > > > _______________________________________________
> > > > > TenTec mailing list
> > > > > TenTec@contesting.com
> > > > > http://lists.contesting.com/mailman/listinfo/tentec
> > > >
> > > > ----------------------------------------------------------------------------
> > > > ----
> > > >
> > > >
> > > >
> > > > No virus found in this incoming message.
> > > > Checked by AVG - www.avg.com
> > > > Version: 8.5.437 / Virus Database: 271.1.1/2763 - Release Date: 
> > > > 03/22/10
> > > > 07:33:00
> > > >
> > > > _______________________________________________
> > > > TenTec mailing list
> > > > TenTec@contesting.com
> > > > http://lists.contesting.com/mailman/listinfo/tentec
> > > >
> > > > _______________________________________________
> > > > TenTec mailing list
> > > > TenTec@contesting.com
> > > > http://lists.contesting.com/mailman/listinfo/tentec
> > > _______________________________________________
> > > TenTec mailing list
> > > TenTec@contesting.com
> > > http://lists.contesting.com/mailman/listinfo/tentec
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec