The part number indicates a 12 volt coil.
73, Jerry, K0CQ
On 3/29/2010 12:21 PM, Denton wrote:
> I used to have a Peggy, and one of the relays on the band pass filter board
> failed...if I remember right, the relay coils for both input and output of
> the filter are wired in series...I replaced mine with two new relays that
> had 6 volt coils.
> ----- Original Message -----
> From: "phil g"<trapperpg@earthlink.net>
> To: "Discussion of Ten-Tec Equipment"<tentec@contesting.com>
> Sent: Monday, March 29, 2010 11:04 AM
> Subject: Re: [TenTec] Pegasus 550
>
>
>> Here is a link to the relay. Also avail. from Ten Tec.
>> http://www.newark.com/jsp/search/productdetail.jsp?SKU=45M7086
>>
>> Fairly straight forward to replace. Unsolder the old, solder in the new.
>>
>> n4zsa
>> ----- Original Message -----
>>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|