I never noticed the pull-in voltage. I had that link bookmarked in my
pegasus files as a replacement. I think it came from this list. I no
longer have my 550, but maybe someone out there is adventurous and could do
a voltage check.
There is a 5v version listed, apparently also made of unobtainium.
http://www.newark.com/panasonic-ew/als2b05tw/miniature-power-relay/dp/45M7085
n4zsa
----- Original Message -----
From: "Dr. Gerald N. Johnson" <geraldj@weather.net>
To: <tentec@contesting.com>
Sent: Monday, March 29, 2010 2:36 PM
Subject: Re: [TenTec] Pegasus 550
The part number indicates a 12 volt coil.
73, Jerry, K0CQ
On 3/29/2010 12:21 PM, Denton wrote:
I used to have a Peggy, and one of the relays on the band pass filter
board
failed...if I remember right, the relay coils for both input and output
of
the filter are wired in series...I replaced mine with two new relays that
had 6 volt coils.
----- Original Message -----
From: "phil g"<trapperpg@earthlink.net>
To: "Discussion of Ten-Tec Equipment"<tentec@contesting.com>
Sent: Monday, March 29, 2010 11:04 AM
Subject: Re: [TenTec] Pegasus 550
Here is a link to the relay. Also avail. from Ten Tec.
http://www.newark.com/jsp/search/productdetail.jsp?SKU=45M7086
Fairly straight forward to replace. Unsolder the old, solder in the
new.
n4zsa
----- Original Message -----
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|