TenTec
[Top] [All Lists]

Re: [TenTec] TITAN 425 PS maintenance

To: tentec@contesting.com
Subject: Re: [TenTec] TITAN 425 PS maintenance
From: Jim Brown <k9yc@audiosystemsgroup.com>
Reply-to: k9yc@arrl.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 03 Dec 2010 11:00:31 -0800
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
On 12/3/2010 10:11 AM, CSM(r) Gary Huber wrote:
>   am looking for comments from anyone who has used this board.

I am a STRONG believer in "If it an't broke, don't fix it."   If 
something in the P/S later fails and you can't easily replace it, THEN 
think about that board. At this point though, all the parts that could 
fail (other than the transformer) are readily replaceable with the 
either same parts or good alternates.

FWIW -- on my three Titans, the only failures I've had in the P/S are a 
few filter caps and some that burned up due to a HV short in the RF 
deck. I'm an active contester, so my amps see a lot of use.

73, Jim K9YC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>