[TenTec] Omni C crystal holder source

["Hulett, Russell" <rhulett1@consolidated.net>]

The Omni C is working ok after adjustments.  I even managed to get 30 and 10M 
working by wedging wire into the loose crystal sockets.  

I asked Ten-Tec whether they still stocked the crystal holders for the Omni 
series, of course the answer was "no".  So, has anyone found a useful 
substitute to warrant difficulty of removing the oscillator board to permit 
replacing the sockets?  Anyone replaced the sockets?  I'd like to repair the 
board properly, the existing crystal holder is in pretty poor condition.

73, Curt KB5JO
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec