I suspect it's cheaper to handle these controls via firmware or software
(and theoretically be easier & cheaper to make changes or additions to in
future rigs) than it is to continue to do it the old fashioned way.
I guess I'd better start stockpiling spare parts for the Corsair...
73
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Louis Ciotti
Sent: Wednesday, May 11, 2011 3:48 PM
To: tentec@contesting.com
Subject: Re: [TenTec] new radio
Seems like a lot of new rigs in the past year have surfaced. I amy
have talked about this here or some other reflector/forum, but what is
up with the reduction of knobs and real meters on radios. I know
there is cost savings to be had with this reduction, but I find it
hard to believe it is that significant. Take the new eagle it has 4
knobs (well 6 if you count the dual knobs). To me there are some
functions that it would be nice to have a dedicated knob for rather
than have to surf a menu get to it. Like Mic Gain, RIT, RF power.
The IC-756proIII replacement hase replace the analog mter with a
digital representation of a meter... it is just not that same to me.
I guess this is why I keep end up using older radios... My 540 still
works great and has a pleasent receiver to listen to. I really wish
someone would make an "old school" radio with lots of knobs, real
meters, etc...
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|