Yes...of course. I have mentioned this Pin 2 in all my postings in
this thread.
My question is whether I can route the voltage away from that pin, to a
replacement 3-pole phone jack without causing any issues. I would just
solder a little jumper wire to the "ring" terminal on a 1/8 inch stereo
jack, to convert the jack from a mono jack for dynamic elements, to a
stereo jack for electret elements. What I don't know is whether
routing/diverting the voltage from Pin 2 like this will cause some
unforeseen problems elsewhere in the circuit.
In other words, I was asking if doing this was a bad idea for some
reason I am too ignorant to foresee !
Thanks.
------------------
Happy Trails.
======================= Richards / K8JHR =========================
On 5/26/2011 16:15, Barry N1EU wrote:
+10V at pin 2 of the 715 mic connector. Didn't you see p2 of the 715 manual?
_______________________________________________
|