Oh... I was afraid of that.
Is there a line-in input on the Omni VI ? If so, maybe he could use
a simple mic preamp to boost the mic signal to line-level, and then let
the rig do its normal adjustment as it would with a mic with higher
output. He might be able to route the mic to the 715 processor, and
then through the preamp to the line-in input on the rig. The preamp
would boost the signal strength to a workable level on the rig.
Alternatively, I have seen very small, low power mic preamp circuits for
boosting a weak mic input to mic input levels (not up to line-level )
and maybe that would give him the wider dynamic latitude he is looking for.
---------------
Happy Trails.
======================= Richards / K8JHR =========================
On 6/22/2011 20:48, Barry N1EU wrote:
> No gain pot on the Omni 6+.
> _______________________________________________
,
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|