Thanks Rick, I agree, changing the old relays to vacuum, etc. would be the best
way to go. I have the documentation from the web for that project and decided I
didn't want to go to all the trouble. If I did that, Measures design would
probably be the one I would use. Anyway, I'll keep plugging away at this
project. I should be able to get it working, as I installed an old original
Ameritron QSK board in my old BTI amp and made it work. I'm pretty sure I just
don't have it set up quite right yet.
________________________________
From: Rick - DJ0IP / NJ0IP <Rick@DJ0IP.de>
To: 'Rod Greene' <w7zrc@yahoo.com>; 'Discussion of Ten-Tec Equipment'
<tentec@contesting.com>
Sent: Friday, August 10, 2012 9:33 AM
Subject: Re: [TenTec] Orion and QSK-5 Switch
Years ago I tried to get the QSK-5 to play with my Omni VI+ and an Ameritron
Amp, which also had a slow open-frame TR-relay. I started buying
replacement protection lamps by the dozens. I never got it to work.
In my opinion, the best thing to do is to swap out the old relay circuitry
in the Amp for a 12v circuitry, and then use a 12v Vacuum relay. Actually
you will need a couple of relays. It's a lot of work but probably a better
solution than the QSK-5. IMHO
MFJ sells two models of inexpensive vacuum relays: 408-8100 (DPST-NO), and
408-8500 (DPST - one pole NO, one pole NC). Use an open collector
transistor to keyed from the TX OUT signal to key the relay. Use a small
reed relay to send the TX EN signal back to the transceiver.
73
Rick, DJ0IP
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Rod Greene
Sent: Friday, August 10, 2012 5:03 PM
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] Orion and QSK-5 Switch
Any Orion II owners using an Ameritron QSK-5 switch with a non TenTec amp? I
am trying to set up a QSK-5 with my O2 and a Kenwood TL-922A. I think I have
it figured out, but have been blowing the protective lamps. Before I replace
them another time I would like to see if anyone has successfully connected
one. I read the great write up by N6MW and checked the documentation at the
TenTec website regarding this. Just want to verify ....
Thanks and 73, Rod/w7zrc
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|