Back in the 1980's, I used to run an HW-8 mobile. This is a two watt CW
only direct conversion radio. For a stretch of time, almost everyday I
would work a European while driving to work. I had a homebrew 6 foot
whip made by winding 24 gauge enamel wire on a 6 foot thin fiberglass
rod. It wasn't much of an antenna and 2 watts isn't much power, but
somehow it worked.
Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com
On 8/12/2012 1:08 PM, Shawn Upton wrote:
Interesting. I have been thinking of tossing the FT-817 into the car, but 5W
into a low-efficency antenna has deterred me thus far. This amp is too big for
that job.
I didn't look to see how it was rated for QSK. Might be the ticket for QRP'ers who like
to tinker; but would like a backup plan "for the rare one".
Shawn Upton, KB1CKT
NAQCC 4723
________________________________
From: Paul Gentry<phgentry@gmail.com>
To: Mr Mike<kf8zn@yahoo.com>; Discussion of Ten-Tec
Equipment<tentec@contesting.com>
Sent: Sunday, August 12, 2012 9:31 AM
Subject: Re: [TenTec] New TT Amp
3db with a QRP rig driving it...Just what an Argonaut or K1, KX1, KX3 need
to go QRO.
On Sun, Aug 12, 2012 at 7:16 AM, Mr Mike<kf8zn@yahoo.com> wrote:
It's Cute, but bottom line....it's a 100 watt amplifier................Why
Bother ????
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|