I am not being obstreperous or critical... serious question:
You guys are saying to "spray" the cleaner ... is it overkill, or
paranoid, or dumb, for me to, instead, spray the cleaner on cotton or
foam swabs, and use them to apply the cleaner to the connector pins? I
don't want to use too much cleaner or have over-spray on the board and
other parts.
Am I being too picky here... or is this a good practice?
Thanks!
================== K8JHR ==================
On 9/16/2012 2:53 PM, cx7tt@4email.net wrote:
....spray, insert several times then wait til dry...
_________________________________________
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|