TenTec
[Top] [All Lists]

Re: [TenTec] Tuning Amp on 17 meters (Antenna impedance)

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Tuning Amp on 17 meters (Antenna impedance)
From: Clayton Brantley <clayton_n4ev@yahoo.com>
Reply-to: Clayton Brantley <clayton_n4ev@yahoo.com>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 19 Apr 2013 15:26:49 -0700 (PDT)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
All this talk about the theory is well and good, but in actual practice, what 
ever works does!
Had an engineer at Collins Radio tell us (in the 60's) that "... the SWR will 
circulate until
it is dissipated."  He just didn't say where.  Could be in the tank circuit or 
the antenna.

Had another engineer that had a favorite saying "If the facts do not conform to 
theory, they
must be changed."


Hope to interject a little levity into the hard core discussion of the theory.

73 Clayton N4EV



________________________________
 From: Stuart Rohre <rohre@arlut.utexas.edu>
To: tentec@contesting.com 
Sent: Friday, April 19, 2013 3:47 PM
Subject: Re: [TenTec] Tuning Amp on 17 meters  (Antenna impedance)
 

The "antenna analyzer" of the MFJ 2xx series, tells you a total impedance, ie 
it does not break it down into capacitive reactance or inductive reactance 
impedance terms, unless you use the advanced operating tips.
Changing the frequency of measurement shows if the impedance is mostly 
inductive as it will increase at a slightly higher frequency away from 
resonance.  EG Xl equals 2 PifL, higher frequency, higher reactance.

Stuart
K5KVH
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>