TenTec
[Top] [All Lists]

Re: [TenTec] OT: THHN Wire in Germany

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] OT: THHN Wire in Germany
From: "Robert Mcgraw" <rmcgraw@blomand.net>
Reply-to: rmcgraw@blomand.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 24 Apr 2013 18:01:33 -0500 (CDT)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
On the flexing point, correctly, there should be a steel center core
messenger for longitudinal strength, then a clockwise wound layer of
copper and then a counter clockwise layer of copper.   The typical
stranded THNN and such does not provide these properties.

73
Bob, K4TAX





> On 4/24/2013 9:11 AM, Paul Kraemer wrote:
>> I have heard stranded is better than solid and contributes to wider
>> bandwidth of the antenna. The more strands of finer wire is better?
>> Comments?
>> Paul K0UYA
> I do not believe bandwidth will be affected one way or the other.
> However, antenna flex IS an issue, being in the wind 24/7/365. And
> AFAIK, stranded wire will handle flexing better than solid wire.
>
> Just my 2 cents...
>
> 73,
>
> Carter   K8VT
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>