Re: [TenTec] The memory keyer in my Orion still cuts off the first dash of the K at the front of my call. I've tried several suggestions but none work. I'm running the 3.0X software. Any other thoughts?

[Carl Moreschi <n4py3@earthlink.net>]

This should not be happening.  I suspect a memory corruption in the 
Orion.  I recommend doing a full reset to the Orion.
1) Power off Orion.

2) Power On holding the VFO B LCK button.

3) Continue holding LCK button until the radio says "Battery Failure".

4) Power off Orion.

5) Power on holding "Main RX/TX" button.

6) Continue holding this button until the radio says reset complete.

7) Do not clear any settings when asked to do so.

8) Power the Orion off and back on one more time.



73,

Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com

On 9/21/2013 3:09 PM, Bob McGraw - K4TAX wrote:
> I have had to add some characters in front of a data string to allow one
> of the radios for another application to key up and start transmitting.
>
> Now that being the case, as your configuration drops the first dash of
> your call, why not add a "T" in front of your call. It would then drop
> the "T" and send your call.
>
> TK2XN. If the "T" is missing then K2XN would be legally transmitted.
>
> 73
> Bob, K4TAX
>
>
>
> ----- Original Message ----- From: "Haney Howell" <haney.howell@gmail.com>
> To: <TenTec@contesting.com>
> Sent: Saturday, September 21, 2013 9:18 AM
> Subject: [TenTec] The memory keyer in my Orion still cuts off the first
> dash of the K at the front of my call. I've tried several suggestions
> but none work. I'm running the 3.0X software. Any other thoughts?
>
>
> > --
> > Haney Howell
> > K2XN
> > Rock Hill, SC
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec