Re: [TenTec] Does this happen to you on transmit...OMNI V ??

[Carl Moreschi <n4py3@earthlink.net>]

Sounds like RF feedback. This can be a tough one to figure out.

Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com

On 2/24/2014 5:29 PM, Scott Shepard wrote:
> I am going  thru a variety of projects presently and am now at the omni V ...it 
> seems on most bands above 80 m if I increase power to past 3/4 point the 
> display blanks out and it gets stuck in tx mode...as though swamped with RF...I 
> have the new chip 9.v2 ...I have to turn the rig off in order to reset the 
> controls...any ideas or similar experience?
>
> Kind regards
>
> Scott VA3IED
>
> Sent from my iPad
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec