In looking at the rear picture I noticed that what appears to be Phillips
head screws + all have the same exact orientation. Man that is some
attention to detail! Or perhaps as one said it is CGI.
As to the front picture, I see some artifacts that point to a CGI rendering
as well.
73
Bob, K4TAX
----- Original Message -----
From: "Barry N1EU" <barry.n1eu@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, June 04, 2014 11:45 AM
Subject: Re: [TenTec] More Junk....
On Wed, Jun 4, 2014 at 2:37 PM, Tom Pennebaker <n4rs@iamotelephone.com>
wrote:
If you will look closely at the rear picture, you can detect poor
quality.
It's only a prototype and maybe we can cut them some slack for that.
Hey, 15 years ago folks were saying the same thing about Bulgarian linear
amplifiers and they turned out pretty good.
Whether or not this ever ends up being a viable product, I'm happy to see
some engineers pushing DDC/DUC SDR development for hams in new directions.
Barry N1EU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|