VFO A and VFO B must be on the same band. If not, press FCN and then A=B.
Release FCN by pressing it again. Then press and hold A/B. SPLIT appears
just to the left of the VFO B frequency display. The bottom VFO is the TX
frequency. To release SPLIT, press and hold A/B.
73
Bob, K4TAX
----- Original Message -----
From: "John" <fraz1@bellsouth.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, July 06, 2014 9:58 PM
Subject: Re: [TenTec] Eagle vs. TS-590S
And, how does one engage SPLIT again in the Eagle....in the heat of
battle?
73 John W4II
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|