| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Zepp? |
| From: | k6jek <k6jek@comcast.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sat, 13 Sep 2014 12:31:56 -0700 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Rick, Gosh, that makes sense but it never occurred to me. Thanks for that little bit of education. Jon On Sep 13, 2014, at 12:19 PM, Rick - DJ0IP / NJ0IP wrote: > That's because the VF of the coax only pertains to the current flowing > inside the coax. > Common mode current is flowing on the outside of the shield where the VF is > about 0.98, not 0.66. _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Zepp?, Rick - DJ0IP / NJ0IP |
|---|---|
| Next by Date: | Re: [TenTec] Zepp?, Rick - DJ0IP / NJ0IP |
| Previous by Thread: | Re: [TenTec] Zepp?, Rick - DJ0IP / NJ0IP |
| Next by Thread: | Re: [TenTec] Zepp?, Rick - DJ0IP / NJ0IP |
| Indexes: | [Date] [Thread] [Top] [All Lists] |