Barry.... Will the Lp-pan2 with amp built in take care of the discrepancy you
note? Thanks! Greg, KC8HXO
Sent from Yahoo Mail on Android
On Thu, Dec 10, 2015 at 7:24, Barry N1EU<barry.n1eu@gmail.com> wrote: I
found the RX366 IF output resulted in a poor panadapter trace and posted
that to this reflector and tentecwiki.org - use the VE7TK mod with Clifton
Labs buffer amp. I suspect the Eagle IF output is no better than the RX366
and also really needs the mod, since it's essentially the same receiver.
I just plugged it into my motherboard soundcard, a RealTek HD or something
like that. It works fine, as do the soundcards recommended on
telepostinc.com
Barry N1EU
On Wed, Dec 9, 2015 at 11:10 PM, Kim Elmore <cw_de_n5op@sbcglobal.net>
wrote:
> Somewhere in the archives, I've read that the way the RX-366 IF output is
> set up creates some undesirable dips and peaks in it.
>
> Kim N5OP
>
>
> On 12/9/2015 9:53 PM, terry foskey via TenTec wrote:
>
>> Barry,Have you or anyone else here ran an LP-Pan on an Orion 366
>> receiver IF out? What sound card did you use, EMU or something else?
>> N5TF,Terry
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> --
>
> Kim Elmore, Ph.D. (Adj. Assoc. Prof., OU School of Meteorology, CCM, PP
> SEL/MEL/Glider, N5OP, 2nd Class Radiotelegraph, GROL)
>
> /"In theory there is no difference between theory and practice. But, in
> practice, there is." //– Attributed to many people; it’s so true that it
> doesn’t matter who said it./
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|