Stuart
The errroneous freq reading was caused by a missing jumper on the back panel
Thanks foir comments
Joe 7mks
----- Original Message -----
From: "Stuart Rohre" <rohre@arlut.utexas.edu>
To: tentec@contesting.com
Sent: Monday, June 13, 2016 11:47:37 AM
Subject: Re: [TenTec] OMNI D Help Needed
Joe, are there plug in cables you had to loosen to remove front panel?
If so unplug and replug a few times to loosen oxides; then invert the
sockets to shake out any debris.
Might be as simple as that for the dial readout issues.
Stuart Rohre
K5KVH
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|