TenTec
[Top] [All Lists]

Re: [TenTec] Century 21 audio hum

To: Discussion of Ten-Tec Equipment <tentec@xxxxxxxxxxxxxx>, Josh Gibbs <Gibbsjj@xxxxxxxxx>
Subject: Re: [TenTec] Century 21 audio hum
From: Howie WA3MCK <wa3mck@xxxxxxxxx>
Reply-to: Discussion of Ten-Tec Equipment <tentec@xxxxxxxxxxxxxx>
Date: Tue, 30 May 2017 17:54:25 -0400
List-post: <mailto:tentec@contesting.com>
Josh,

Thank you
for the info on the swamping resistor placement and installation.

I have an analog C21. Bought it in the late 90's, had it on the air for a
few years, sold it to Joe N2CX, he had it for 15 or 20 years, and I bought
it back s few years ago.

It's beat up cosmetically but works fine. Replaced the finals not too long
ago... and now the PTO is starting to go - mechanically that is!

Ok - just checked - yes, when I turn down the volume there is a slight hum
with my old 8 ohm mono headphones.

I prefer to use the internal speaker which is fine for me and why I may
have not noticed the low/level hum.

By the way, I emailed TenTec several months ago concerning the availability
of a PTO repair kit for the C21 analog xcvr. I received an answer a few
weeks ago stating that they were in transition and to keep an eye on their
website. Nothing seen yet.

Howie WA3MCK





On Tuesday, May 30, 2017, Josh Gibbs <gibbsjj@xxxxxxxxx> wrote:

> Hi Howie,
>
> I opened up the plug on my phones (housing unscrews on this one, other
> plugs might not), unsoldered the wire that was connected to the 'tip'
> terminal, and put the resistor between that tip terminal and the wire that
> I unsoldered.
>
> I just used some test leads to clip in different value resistors when I was
> figuring out the best resistor value.
>
> Is your C21 the Digital or Analog version? How many Ohms are your
> headphones? You don't hear any loud humming with the phones plugged in and
> the audio turned down all the way?
>
> -Josh WA7FPV
>
> On Tue, May 30, 2017 at 2:03 PM, Howie WA3MCK <wa3mck@xxxxxxxxx
> <javascript:;>> wrote:
>
> > Hi Jim,
> > I don't have any noticeable hum on my C21. I however the swamping
> resistor
> > is a good idea. If I may ask - how and where did you install it?
> > Howie WA3MCK
> >
> >
> _______________________________________________
> TenTec mailing list
> TenTec@xxxxxxxxxxxxxx <javascript:;>
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@xxxxxxxxxxxxxx
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>