OMNI VI+ rules for what I do - plain and simple.
I have installed 2.8 Khz SSB filters and performed N1EU's audio tap.
This is fed into my computer soundcard and the VI+ sounds as good if not better
than the SDR...
de Wb8yqj Don
-- So yes now you raise the TCXO 100 hz for 160m and you end up 50hz high on
15m, splitting hairs at this point. Only thing I split hairs over was the time
display which I found a new crystal for but not the right impedance so now
working but loses time so just turned it off.
From: John King <k5pgw@yahoo.com>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Cc: Don Rasmussen <wb8yqj@yahoo.com>
Sent: Monday, March 12, 2018 12:55 PM
Subject: Re: [TenTec] Omni VI+ 100 hz off exactly on readout
To Don and all:
The Omni VI + is low on the following bands by the following amounts:
160 meters................ 99 hz low
80 meters 100 hz low
20 meters 60 hz low
17 meters 60 hz low
15 meters 50 hz. low
10 meters 60 hz low
Nothing has ever been adjusted in 25 years since purchased from Ten Tec. It
has been back to Ten Tec for service periodically for updates and a couple of
minor issues. This is the best transceiver I have ever owned and the easiest to
use. A fantastic radio !!
Thanks and 73, John, K5PGW On Monday, March 12, 2018 12:13:45
PM, Don Rasmussen via TenTec <tentec@contesting.com> wrote:
Be sure to check that the difference is seen on all bands, band crystals also
change sometimes...
de Wb8yqj Don
My 25 year old Omni VI+ has gradually crept up 100 hz on the readout. I have a
new TCXO that I recently purchased but I would like to make an adjustment to
bring the BEAUTY UP 100hz so it will read 3.925 instead of 3.924.9 when it is
in fact receiving on 3.925.
Thanks and 73, John, K5PGW
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|