I'm improving the grounding on my Beverages -- using 2 4' rods at the feed
and endpoint of each. However, one of them (single-wire, terminated) ends at
a point where the ground is very rocky. I can only get a ground rod in about
1 foot. There is a standard barbed wire fence going by less than 10' away,
with normal T-posts. Would hooking to it as a ground be of any use? Or,
Should I just use 4 or 5 1' ground rods? Or lay some bare copper wire on
the ground (I can't bury it)? Or some combination? Thanks.
--
Dave NØRQ
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
|