Mine are installed thru the woods and I spent considerable time trimming out
low growth plus interfering branches. The path doesnt deviate over a feet in
order to pass to the side of trees and I had to reroute a few when I
discovered my eyeball and compass werent in agreement!
Nobody ever said it was easy but the end results are good with excellent
patterns and noise reduction.
The 2 wire reversible Beverages are mounted to trees using electric fence
insulators found locally in bags of 25 at a feed and grain/pets/horsey set
shop.
Carl
KM1H
----- Original Message -----
From: "Wayne Willenberg" <wewill747@gmail.com>
To: <Topband@contesting.com>
Sent: Monday, June 18, 2012 2:45 PM
Subject: Topband: Beverage Antennas & Trees
>I am preparing to install a reversible Beverage antenna, using 450 Ohm
> ladderline. All of the components are from DX Engineering. The maximum
> length I could fit on my property was 480ft. This would be the first of
> my
> receive antennas for my first venture into 160 and 80M.
>
> Here is my concern. To fit an antenna of that length, oriented in a N-E
> or
> S-W direction, it will have to go through a think grove of trees (many are
> over 75ft high) and an even thicker underbrush of younger trees and junk
> growth. Despite all of the trees, I think I can keep it pretty much in a
> straight line. How significant will the attenuation be caused by all of
> the branches and leaves?
>
> Thanks for your help to a newcomer to your band.
>
> Wayne, KK6BT
> _______________________________________________
> UR RST IS ... ... ..9 QSB QSB - hw? BK
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1424 / Virus Database: 2433/5081 - Release Date: 06/20/12
>
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
|